Adjust bearings to a free rolling fit with no end play by varying the number of shims (6 Fig. Idle speed stop screw on the carburetor throttle should be adjusted to provide the correct low idle engine speed.ġ98. Place controls in operating position by completely opening the choke.ġ01. A slightly richer adjustment (counter-clockwise until speed drops slightly) may be desirable for a particular fuel or operating condition. 61) until the highest engine speed is obtained. Immediately after the engine is started, bring the throttle to the fully open position and with the choke in the fully closed position, rotate the starting screw(N- Fig. The Ensign model Mg 1 carburetor and model W regulator have three points of mixture adjustment, plus an idle stop screw.ġ00. Like other LP-Gas systems, this system is designed to operate with the fuel tank no more than 80% filled. The LP-Gas system available is designed and built by Ensign Carburetor Co. This repair manual includes wiring diagrams for all Allis-Chalmers tractors listed, except Model 175.īook Excerpt: Allis-Chalmers Repair Manual D-10, D-12, D-14, D-15, D-17, 160, 170, 175 The Allis-Chalmers Repair Manual D-10, D-12, D-14, D-15, D-17, 160, 170, 175 covers the following tractors:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |